Project NSR

I have already mentioned early on in the break down process that the boot/ tool box lid catch was an issue. Well in the seance that it wasn't there that is. I made a quick temporary fix using tie wraps that worked perfectly well but for obvious reasons I wanted something a little better. Still with no original part available I opted to fabricate something out of some old bits of aluminium that I found lying about. It didn't need to be a work of art as it's all a bit out of sight but it needed to be functional. One of the scraps I had was an L bracket with two holes along one edge and a slotted hole in one corner of the other edge. The other piece was a straight piece with a long angle cut out of one corner, it was also base coated green unlike its plain ally, L shaped buddy. Both pieces had rounded corners and the L bracket had two sprung anchor nuts with it that would prove to be useful. The L bracket just so happened to have its two holes drilled exactly where the ...

During the run up I had noticed that I had some rather funky goings on with my indicators. My fronts were permanently on only going out when that sides indicator was selected and the rears were flashing on the wrong sides. that was if they worked at all as they were pretty intermittent. As I was stripping down the bike I took a look at the wiring under the tail unit. All the wiring was connected up correctly yet I was still getting a back to front indication.  I disassembled all the connections A took the time to polish the little brass connectors to reduce resistance in the system and put it all back together again. I tried swapping the wiring round, leaving the common earth as it is and swapping the live wires. Success!  Everything worked as it should but why only when the wiring was plugged in incorrectly?  This was baffling for 10 seconds longer than it aught to be when I realized the indicators had just been installed on the wrong sides by the importer. So ...